All Cryselco products comply with EC Directives and the quality standard conforms to BS EN ISO 9001.

We are members of Lumicom and fully comply with the Waste Electrical and Electronic Equipment legislation (the WEEE Directive) on recycling.

Our range is designed for use in the UK (240 volt/50Hz) with fluorescent tubes (unless otherwise stated). However we can offer switch start 110 volt gear and high frequency can operate at 60Hz.

Please note that high or low temperature extremes can affect the operation of fittings. Acceptable ambient temperature is 0°C to 35°C.

Tubes are not supplied with fittings.

Please note that unless specified, no fixing brackets are supplied with fittings as installation is left to the contractor on site.

In an attempt to continuously improve products, the company reserves the right to change the specification of any product without prior notification.

Emergency conversions are available for most Cryselco Fluorescent luminaires. Wherever possible the emergency gear will be housed within the luminaire (integral) but there are some cases (e.g. heat build up, physical size etc.) where it will be necessary to either use different control gear for the fitting or mount the emergency gear outside the luminaire in a remote box. The luminaire would be pre-wired ready for a simple on site wiring into the remote gear box which must be mounted within 0.5 metres of the luminaire. Most of our emergency conversions are maintained where one of the standard tubes will immediately restrike in the event of a complete mains supply failure and provide light for three hours.

Please refer to the Proteus and Meteor ranges for emergency conversions on these ranges.